FREE CIRCUIT DIAGRAMS 4U: Battery-powered Night Lamp

Free Electronic Circuits,Schematic Diagram,Circuit Diagrams

Thumbnail image that says sleek button using photoshop that links to a Photoshop tutoril.

free, electronic circuit, circuit diagram, circuit schematic, schematic diagram, electronic diagram, audio, amplifier, power supply, guitar effect, current loop, current limiter, video, receiver, transmitter, transceiver, transistor, radio frequency, rf, active filters, digital, analog circuit, pwm, micro controller Free download

Electronic Circuit,Schematic Diagram,Circuit Diagrams

electronic circuit, circuit diagram, circuit schematic, schematic diagram, electronic diagram, audio, amplifier, power supply, guitar effect, current loop, current limiter, video, receiver, transmitter, transceiver, transistor, radio frequency, rf, active filters, digital, analog circuit, pwm, micro controller Free download

Saturday, August 29, 2009

Battery-powered Night Lamp

This circuit is usable as a Night Lamp when a wall mains socket is not available to plug-in an ever running small neon lamp device. In order to ensure minimum battery consumption, one 1.5V cell is used, and a simple voltage doubler drives a pulsating ultra-bright LED: current drawing is less than 500µA.An optional Photo resistor will switch-off the circuit in daylight or when room lamps illuminate, allowing further current economy.This device will run for about 3 months continuously on an ordinary AA sized cell or for around 6 months on an alkaline type cell but, adding the Photo resistor circuitry, running time will be doubled or, very likely, triplicated.

Night Lamp

Parts:
R1,R2___________1M 1/4W Resistors R3_____________47K 1/4W Resistor (optional: see Notes) R4____________Photo resistor (any type, optional: see Notes) C1____________100nF 63V Polyester Capacitor C2____________220µF 25V Electrolytic Capacitor D1______________LED Red 10mm. Ultra-bright (see Notes) D2___________1N5819 40V 1A Schottky-barrier Diode (see Notes) IC1____________7555 or TS555CN CMos Timer IC B1_____________1.5V Battery (AA or AAA cell etc.) IC1 generates a square wave at about 4Hz frequency. C2 & D2 form a voltage doubler, necessary to raise the battery voltage to a peak value able to drive the LED.

Notes: * IC1 must be a CMos type: only these devices can safely operate at 1.5V supply or less. * If you are not needing Photo resistor operation, omit R3 & R4 and connect pin 4 of IC1 to positive supply. * Ordinary LEDs can be used, but light intensity will be poor. * An ordinary 1N4148 type diode can be used instead of the 1N5819 Schottky-barrier type diode, but LED intensity will be reduced due to the higher voltage drop. * Any Schottky-barrier type diode can be used in place of the 1N5819, e.g. the BAT46, rated @ 100V 150mA.